Also ran on Vista and XP with no problems. Even does the intricate bit around the shoe on the Good Year logo without a problem on a 150mm wide graphic. Have to say for anything less than industrial use I can't see anyone needing much more than a PCut - I've cut about 40m of 320mm now in a day and a bit and it's not even flinched. Hopefully this'll help anyone else out who's stuck in the future. Took me about 30 mins to set it up and have it working including digging an old PC out to drive it and building the stand. Check the port speed on the cutter is set to 9600. Works fine, no issues setting it up however I can see where many may struggle as it's not exactly plug and play! Navigate to Device Manager and disable Com2 right click, disable if already present. Have to say for anything less than industrial use I can't see anyone needing much more than a PCut - I've cut about 40m of 320mm now in a day and a bit and it's not even flinched.ĭear all, Picked a P-Cut up on Saturday and been happily chopping graphics out for most of the weekend. If it's in your computer, Driver Robot can see it. I've never had this much trouble installing anything in my life! Have you got the FTDI convertor installed correctly as this will make a difference to the setup and what software you are cutting from.Ĭontrol System: Risc Micro-controller. Tried the Add New Hardware Wizard from the control panel but no joy there either. ※ Download: ?dl&keyword=artcut+2009+usb+driver+download&source=

Artcut usb driver download